Pine Needle Basket

 Coiled Basketry has been found worldwide in a variety of indigineous cultures including Uganda, England, Australia, and many regions in the United States.  They form a very tight container and can include delightful colors and patterns.  Along the western states, these baskets have been made from the long Ponderosa Pine needles.  Trees will naturally shed a great number of these needles each fall and they can be collected from the ground.  

I collected these needles at our SCA Principality's Fall Coronet in Chiloquin, OR.  The first step is to make sure most of the needles are fully intact and mold-free, and it's best for them to be completely dried before beginning.  Once that is assured, soak the needles in warm water for at least an hour or until they are a little more pliable.  As the basket gets wider, this is less necessary, but it keeps the long needles from snapping.  

The materials you'll need for this are:

~Lots of pine needles (I used a large, double handful for this tiny basket)

~Thread of choice - waxed or sinew is preferred, I used embroidery floss

~Needle

~hollow threader - large feather shaft, tightly rolled piece of paper, portion of drinking straw or pen exterior.  The interior circumference of this will determine your fiber bundle size.

    When the needle bundles fall from the trees, they have a papery covering over the tree-end.  This should be removed from each set of needles before working.  Stuff the tube with needles so they are all going the same direction, lining up the tree-end on one side.  The tube should be snug, but not so tight that the needles can't continue to slide through.  With all the tree-end (connected) needles, start tightly wrapping with your thread, tucking the short end under the wrapping.  Continue this for about an inch before folding the wrapped area over as pictured above.  Thread needle on long end and past through wrapped areas several times to secure.  Continue wrapping and stitching until secure.  

    As you work, add more pine needles going the same direction into the center of the tube bundle any time it loosens up.  When you run out of thread, try to tie a new strand on in a way that the knot will be covered as you continue to work.

  

  After the center of your coil is tightly secure, continue wrap needles around and secure with stitches by going around the new and back under the last coil round.  It will look most consistent if you put each additional row's stitches coming through the stitch of the previous row, splitting it.  Eventually you will need to add extra stitches in between.

    Continue until the base of your basket is the desired size. 

At this point, you will need to pull the needle bundle on top of the previous row as you stitch along in order to begin shaping the sides.  Continue in this direction until the desired height is achieved.  Continue stitching around until all needle ends are tacked down.

  

    Enjoy your coiled basket!  I found this to be very strong and sturdy.  It could hold very tiny things without them falling through, perhaps even liquid if it was made well.